Troubleshooting
The following is a collection of possible issues with the Katalyst Training System. If you have additional
questions or concerns, please contact Katalyst.
The impulse pack
doesn’t turn on
Connect the charger to the impulse pack. The LED status indicator should turn solid
white. Allow the impulse pack to charge for a minimum of 30 minutes. After at least
30 minutes have passed, remove the impulse pack from the charger and turn it on.
The app cannot
pair with the
impulse pack
Ensure that your impulse pack is powered on. If your iPad still cannot find the
impulse pack, do the following:
1. Ensure that the impulse pack is powered off.
2. Open Bluetooth from the
Settings
app on your iPad.
3. From the
Bluetooth Devices
section, locate
Katalyst
. If found, tap it and
select
Forget this device
.
4. Hold the power button for the impulse pack for 5 seconds until the LED
status indicator is rapidly flashing blue.
5. Launch the Katalyst App on the iPad and follow the instructions to pair
your impulse pack to the iPad. Ensure that the impulse pack is close to the
iPad.
The Katalyst app stops training, disables any channels with a bad connection, and
displays the channels which are having issues.
Ensure that you are wearing your base layer and that the pads of the suit are
adequately soaked with water. Additionally, ensure that the vest connector and
shorts connector are properly attached. Then press
Resume Workout
on your
Katalyst app.
Stimulation is
weak, even on high
intensities
Pause the workout and inspect the suit to ensure that all pads are adequately
soaked with water. If required, re-wet the pads.
If the stimulation is still weak, stop training. Katalyst recommends replacing your
suit as it may be worn out.
Stimulation causes
discomfort or a
burning sensation
Pause the workout and inspect the suit to ensure that all pads are adequately
soaked with water. If required, re-wet the pads. If the sensation continues, confirm
that the suit is properly tightened to ensure proper compression.