Katalyst Training System - Page 44

40
WEEE
Waste in Electrical
and Electronic
Equipment. Indicates
a product should not
be disposed of in a
landfill; the black bar
indicates that the
equipment was
manufactured after
2005.
-
EN 50419:2006
Marking of electrical
and electronic
equipment in
accordance with
article 11(2) of
directive
2002/96/EC
(WEEE)
Stand-by
Indicates a sleep
mode or low power
state. The switch does
not fully disconnect
the device from its
power supply.
5009
IEC
60417:2002
Graphical Symbols
for Use on
Equipment
FCC Marking
FCC marking indicates
the electronic device,
which sold in the
United States, is
certified and the
electromagnetic
interference from the
device is under the
limits that are
approved by Federal
Communications
Commission.
-
Federal
Communications
-
Do not use if
package is
damaged
Indicates the device
should not be used if
the package has been
damaged or opened.
5.2.8
ISO 15223-
1:2016
Medical devices –
Symbols to be used
with medical device
labels, labeling and
information to be
supplied – Part 1:
General
requirements
Do not dry
clean
Indicates the garment
can be safely dry
cleaned without
damage.
-
ISO 3758:2012
Textiles – Care
labeling code using
symbols
Do not iron
Indicates the garment
can be safely ironed
without damage.
-
ISO 3758:2012
Textiles – Care
labeling code using
symbols
Do not tumble
dry
Indicates the garment
can be safely tumble
dried without
damage.
-
ISO 3758:2012
Textiles – Care
labeling code using
symbols