Keba KeContact P30 x-series - Connection Via Router or Switch

To Next Page

To Previous Page

P30 x-seriesSystem overview

Configuration manual V4.01

3.2.3 Connection via router or switch

If there are multiple slave charging stations, these must be connected to the

master charging station via a router or switch. The connection of the charg-

ing station to the router/switch is made via LAN.

Illustration3-5: Connection via router or switch

1 ... Router/Switch 2 ... P30 x-series (master)

3 ... P20/P30 c-series (slave)

Using a router

In a network connection using a router, the router automatically provides the

functionality of a DHCP server in most cases.

Information

If the IP addresses are assigned externally (for example, by routers with ac-

tivated DHCP server), the IP addresses must not be in the following range:

192.168.25.xxx

Using a switch

For a network connection using a switch, the master charging station must

be configured as a DHCP server. The IP addresses are then assigned by

the master charging station.

Other manuals for Keba KeContact P30 x-series