P30 x-seriesConfiguration
Configuration manual V4.01
26
© KEBA
External TCP Meter
Here you can set whether the charging station can read out the measured
values from external meters for dynamically adjusting the charging current.
All the necessary configurations for the external meter can be found in this
part. This menu is only available if the charging station is operated as a sin-
gle charging station (not available on charging network).
Display Text
Settings for the text can be made here, which is shown on the display and
describes various operations of the charging station. The language of the
text can be changed, the display duration can be set and the displayed text
itself can be changed.
When entering text, make sure that no special characters or umlauts are
used!
4.3.2 User menu
The user menu contains important information and settings for the user. It is
divided into the following areas:
● Help
● Licenses
● User settings
● Logout
User settings
This section allows you to make changes to the web interface user name
and associated password. The "recovery key" is also displayed here, which
can also be found on the configuration label. If you have forgotten the web
interface password, you can reset it with the displayed recovery key.
Information
The recovery key must be kept for the entire life of the product!
4.4 Enabling the DHCP server
To simplify the setup of a charging network, the master charging station can
be configured as a DHCP server. This function is required for the network
configuration when the master and one slave are connected directly or when
a network connection is implemented via switch.
The DHCP server of the master charging station is deactivated in the deliv-
ery state and can be activated via the configuration in the web interface.
To Next Page
Loading...
