P30 x-series Configuration
Configuration manual V4.01
25
© KEBA
Operating Mode
Here you can determine whether the charging station is operated as a single
charging station or as a master charging station in a charging network.
The number of slaves must be entered for a charging network. In addition,
all attached slave charging stations must be entered with their respective se-
rial numbers. Otherwise, the slave charging station will not be recognized by
the master charging station in the network. The serial number is printed on
the rating plate of the slave charging station.
Device
The basic settings for the charging station are configured here (setting the
authorization function, synchronizing the time of the charging station with the
time of the browser, allowing USB sticks to save and load files).
Information
After time synchronization the charging station is restarted.
Phase Assignment
The connection type (1-phase or 3-phase) of the charging station ist se-
lected here. With 1-phase connection, the terminal used can also be se-
lected. For a charging network, the connection type of the slave charging
stations is also selected here.
Charging Parameters
The nominal supply voltage of the charging station is selected here. The cur-
rent limits for the charging network can also be set here.
Network Connection
The network communication can be selected and configured here.
WLAN / WiFi Access Point
The WLAN access point can be configured here and enabled or disabled as
required.
Proxy
All the necessary configurations for using a proxy server can be found in this
part.
OCPP
All the necessary configurations for connecting to an OCPP backend can be
found in this part.
To Next Page
Loading...
