P30 x-series Introduction
Configuration manual V4.01
7
© KEBA
1.4 Intended use
The charging station is intended for charging electric vehicles (such as elec-
tric cars). The connection of other devices (such as power tools) is not al-
lowed.
The charging station is suitable for indoor and outdoor use. The charging
station has to be installed vertically on a wall or on a floor-mounted column.
The surface for the installation must be flat and suitably stable (e.g. brick
wall, concrete wall). The respective national regulations must be observed
with regard to the installation and connection of the charging station.
The intended use of the device always includes the compliance with the en-
vironmental conditions for which this device was developed.
The charging station has been developed, manufactured, tested and docu-
mented in accordance with the appropriate safety standards. If the instruc-
tions and safety instructions described for the intended use are observed,
the product will normally not pose a risk to the health of persons or damage
to property.
Not observing the safety instructions can result in risk of death, in-
juries and damage to the device! The device manufacturer assumes no li-
ability for resulting claims!
1.5 Guarantee
Only the maintenance work expressly permitted by KEBA may be performed.
Any other manipulations to the device will also result in loss of warranty.
Only the covers described in the instructions may be opened. If one of the
covers is sealed by a lead seal, it is not permitted to be opened by unautho-
rized persons. If the lead seal is broken, the device loses its specific suitabil-
ity and may no longer be put into operation due to the resulting incorrect
marking.
To Next Page
Loading...
