4.2 Operation 4.2
INSERTING THE BLADE AND SETTING THE DEPTH
1. The blade is inserted from the back of the blade holder, push it fully forward and
tighten the wingbolt.
2. To set the blade for a repeatable cutting depth unclamp the blade and turn the knob at
the front of the cutter, clockwise to increase blade depth & counter clockwise to decrease.
Re-clamp the blade before use.
TIP - Set the blade depth so that you are only just cutting through the board, it takes
much less effort and produces a better cut.
➠
To Next Page
Loading...
Need help?
General