4.1 Operation 4.1
The Evolution Cutter Bar has been designed to cut a variety of boards to a thickness of
10mm (0.4”) using a Medium Duty utility blade.
However, an increased cutting depth of 13mm (0.5”) can be obtained using the
KEENCUT XR utility blade, available from your distributor or Keencut.
Consideration should be given to the toughness of the board being cut and the maximum
depth of cut. It is recommended that heavy materials such as PVC foamboard should
only be cut to a maximum of 6mm (0.25”) whereas, lighter materials like foam centred
board can be cut up to 13mm (0.5”) thick using the KEENCUT XR blade
To Next Page
Loading...
