4.4 Operation 4.4
...for cutting foam centred board, PVC foamboard and heavyweight materials.
Place your hand on the cutter, as shown, with the palm of your hand positioned over the
silver coloured bar on the front edge of the cutter. Place your left hand on the finger grip
of the straight edge, depress the cutter and push it away from you to cut. Dependent
upon the nature and thickness of the material you may need to take more than one cut
gradually increasing the depth.
..for cutting film and lightweight materials.
Place your hand on the cutter, as shown, with your finger tips positioned on the silver
coloured bar across the front edge of the cutter. Depress the cutter and pull to cut, there
is no need to hold the cutter bar down when cutting.
➠
➠
To Next Page
Loading...
