4.6 Operation 4.6
To fit the Textile Cutter, remove the utility blade, unscrew the Thumb Cap and position the
attachment on the side of the Cutting Head then replace the Thumb Cap.
Position the textile on the machine and lower the Cutter Bar. Rotate the red safety guard
into the cutting position, lower the Cutting Head in the normal way and draw the cutting
wheel along the textile in one small motion.
This facility can also be used to cut thin papers and many other flimsy materials, always
carry out a test cut on materials that have not been cut using this method.
➤
➤
To Next Page
Loading...
