KeepGuard CAM - PLAYING BACK;DELETING the PHOTOS;VIDEOS

3534
motion that is detected by it will trigger the capture of photos or videos as
programmed in the SETUP Menu. Be sure you have read the descriptions of
the Capture Number, Video Length, Interval and Sensor Level parameters.
Please note, the PIR is strongly sensitive to ambient temperature. The greater
the temperature diference between the environment and your subject, the
farther the possible sensing distance. The average sensing distance is about
45 ft.
Before leaving the camera unattended, please check for the following:
• Are the batteries or DC power supply inserted/connected with correct polarity
and is the power level is sufficient?
• Does the SD card have sufficient available space and is its write-protection
(lock) switch off?
• Is the Power switch in the ON position? (Do not leave it in SETUP).
PLAYING BACK/DELETING the PHOTOS/VIDEOS
After you have setup, mounted and activated your KeepGuard Cam, you will
of course be eager to return later and review the images it has captured for
you. There are several diferent ways this can be done.
Reviewing Images on the KeepGuard Cam LCD (Models with Color
Viewer only)
• Put the power switch in SETUP mode (switch to OFF first).
• Push the OK(Replay) key to enter image review mode.
• Use the UP/DOWN keys to scroll through your photos or videos. The right
corner of the display will indicate″JPG″for still photos,and a film icon for video
iles. Press the RIGHT(Shot) key to review a video.
• Push MENU to delete an image. Image delete mode works as described
below. To exit image review mode, press the OK key.
Reviewing Images on an External Video Monitor
A TV monitor can also be used to play back pictures (or videos) from the
device. Connect a TV monitor or a viewing device (such as a digital picture
frame) that has a standard composite video input (RCA jack) to the
KeepGuard Cam′s ″TV Out″mini jack using the supplied cable. Then:
• Put the power switch in SETUP mode (switch to OFF first).
• Press the OK key. The most recently
captured image will be shown on the
video monitor. For video clips, press
the SHOT (RIGHT) key to start playing,
press again to stop.
• Press the UP key for the previous
photo or video and the DOWN key
for the next one. When viewing images,
the total number of all images in the SD card and the index of the displaying
image are shown in the center of LCD and at the bottom of the video monitor
respectively.
• Press the OK key to return to live preview state (SETUP mode) when
playback is finished.
Deleting Photos or Videos
If you see a photo or video during playback on the LCD or video monitor that
you want to delete, it can be done easily without leaving SETUP mode:
• Press the MENU key. You will see the first″Delete″screen, which lets you
selects the option to delete only the currently displayed photo/video, or all