KeepGuard CAM - USING THE SETUP MENU TO CHANGE SETTINGS

NOTE: Always move the power switch from OFF to SETUP
mode. It is possible that the camera could lock up if it is
switched from ON to SETUP mode. If this occurs, simply move
the switch to OFF and then push it up to SETUP again..
Fig. 3: SETUP Information Screen (standard display model
shown)
USING THE SETUP MENU TO CHANGE SETTINGS
The main purpose of the SETUP mode is to allow you to change
the settings of the camera′s parameters (16 different ones are
available) so your KeepGuard Cam operates exactly the way you
want it to. You will do this by entering the SETUP Menu and
1312
Changing Parameter Settings in SETUP Mode
A wide range of options or “parameters” are provided to allow you
to set the KeepGuard Cam to your operational preferences. To
change the setting of any parameter you must first switch to the
SETUP mode. Once in SETUP mode, pressing the MENU button
will allow you to select any parameter and change its setting. The
name of the parameter and its current setting will be shown on the
LCD. Pressing the RIGHT or LEFT key scrolls to the next or
previous parameter (RIGHT key to move on to the next parameter
and LEFT key to go back to the previous parameter), and pressing
the UP or DOWN key lets you select a different setting for the
currently displayed parameter. Once you have selected your
preferred new setting for a parameter, press the OK button to save
the new setting (actually change it). When have are finished
changing the settings of one or more parameters, press MENU
again to exit the SETUP menu. MENU can also be pressed
anytime you want to cancel changing a parameter's setting after a
new setting has been selected (but OK has not been pressed yet).
After setting the parameters to your preferences, be sure to move
the switch to ON to begin actually taking photos or videos. No
images will be captured if the switch is left in the SETUP position
(unless you press the RIGHT/Shot key after exiting the menu)-in
fact, the camera will power of automatically after a few seconds
with no key pressed.
Fig.4: Selecting Parameter Settings
pressing the keys on the remote. which will show you each
parameter and its setting.