Press the pedal with your foot while turning the accelerator a little. Release the pedal when you start the
engine. Warm up the motor by adjusting the power gradually for half a minute. After a few seconds return
the choke lever to its initial position. It is essential to follow steps 1 to 4 in the Start with Run starting procedure.
To prolong the life of the motor, you should warm up the motor for two minutes before starting the
movement. Never push the engine too hard when it is cold.
USE OF THE NEW ENGINE
Before you can demand the maximum from your engine, you must travel 1000 km. This period is vital for
the performance and future durability of your motorcycle. During the initial period you should never
accelerate the engine to maximum, otherwise it will cause internal damage and/or premature engine wear
whichThey will not be guaranteed.
During this period the revolutions per minute should never exceed more than 6 500 rpm. (You will need
to use the gear shifts to control the revs.) You must strictly follow the following steps during the first 1000
km for a correct break-in of your engine.
From 0 to 150 km. During this period of time do not exceed the throttle by more than a quarter of its
maximum opening. Stop the engine for 10 minutes to cool down after 1 hour. management. Do not drive for
long periods of time, make constant changes of speed.
From 150 to 500 km. During this period of time do not exceed the throttle by more than half of its maximum
opening. Never go full throttle. Do not drive constantly, make constant changes of gears. From 500 to 1000
km.During this period do not exceed the throttle by more than three quarters of its maximum. opening. Do
not drive for long periods of time, make constant changes of speed.
15
To Next Page
Loading...
