It is recommended that these points be inspected by an Authorized Service Center for optimal
performance, however, if the end user decides to do it themselves, it will not replace the service
schedule provided in the Warranty Manual. Failure to comply with this service schedule will
automatically void the warranty.
When using the motorcycle in very dusty areas, you should increase the frequency of services.
19
CHECK AND REPLACE THE SPARK PLUG
1. Remove the spark plug cap and clean the dust around it. Remove the
2. spark plug with the special spark plug wrench.
3. Clean the spark plug with a wire brush. Check
4. the wear and corrosion of the electrodes.
5. Replace the spark plug if it is damaged. Adjust
6. the electrode gap to 0.6 – 0.7 mm
7. Check that the spark plug seal is in good condition.
8. When assembling the spark plug, insert it by hand to ensure that it fits
straight and does not damage the thread, then tighten with the wrench
and place the cap firmly.
Spark plug seal
GAP
0.6 – 0.7mm
Brand
NGK
Model
CR7H-SA
The recommended spark plug is the NGK CR7H-SA,
however other brands can be used.
To Next Page
Loading...
