Follow our recommendations to avoid causing damage to your motorcycle:
1. Rinse the motorcycle with cold water, making sure to remove any loose dirt.
2. Use a soft cloth and dampen it with water only, rub the dirty areas. Rinse the
3. motorcycle again to remove the soap with plenty of clean water. Dry the
4. motorcycle with a soft, dry cloth.
5. Start the engine and let it run for 1 to 3 minutes.
6. Lubricate the drive chain.
WASHING THE SEAT
It is recommended to clean synthetic parts as follows:
1. Dampen a wool or cotton cloth and wipe it over the seat surface.
2. If the seat still has embedded dirt, use special cleaning and maintenance products for synthetic material
and artificial leather that do not contain solvents or, failing that, use a light solution of mild soap,
preparing it with a liter of water and neutral soap.
3. For special stains use a specific remover for each stain. Avoid wetting the
4. surface too much and take care that water does not seep through the seams.
5. Dry with a soft, dry cloth.
It is very important that when cleaning the motorcycle you take care not to wash the following parts with high
pressure water: Start switch, electrical equipment switch, gauges, air filter, under the seat, handlebars and
exhaust. To wash the unit, use only water and a flannel. Do not use detergents. It is important that you dry the
vehicle completely with a dry cloth. Test the brakes before operating the unit.
23
To Next Page
Loading...
