Keiser M7i - Operation and Preparation; Pre-Operation Checklist

10
M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
If all assembly requirements have been met, and you have read and understood the Important Safety Instructions, test ride
the M7i under the supervision of a spotter. Adjust and ne-tune as needed. It is recommended that the M7i is pedaled in a
forward rotation.
M7i Proper Operation Check:
PROPER OPERATION CHECK
1. Computer Display powers ON at one full pedal revolution.
2. Left and Right Recoilers are installed correctly (refer to “Recoilers Installation” section, page 8).
3. Resistance Lever cycles GEAR 1—24 (GEAR 88 = Emergency Brake).
4. Adjustment Knobs properly engage into the Handle position holes and are hand-tight (refer to “Adjustment Knobs”
section, page 12).
5. The M7i is properly stabilized, level to the oor (refer to “Leveler Foot” section, page 11).
6. Footstraps swivel up to position; no damage, wear, or broken parts detected. The hook and loop parts fasten properly.
WARNING: To reduce the risk of serious injury, read all important precautions and instructions in this manual
and all warnings on the M7i before operation. Failure to perform the Proper Operation Check prior to operation of
the M7i will void your warranty and could result in serious injury.
The following pages are a brief overview of the features necessary for safe operation.
Figure 5. M7i Proper Operation Check
1
2
3
5
6
4