Keithley 2010 Quick Reference Guide

7
Front Panel
Operation Summary
Power-on defaults
Power-on defaults are those settings the instrument
assumes when it is turned on. The Model 2010 offers
two choices for the settings: user or factory. With user,
the instrument will power-on to the settings stored in
memory by the operator. With factory, the instrument
will power on to the factory default settings.
To save present configuration as user settings:
1. Configure the instrument as desired for USER
default.
2. Press SHIFT and then SAVE.
3. Use the ▲ and ▼ keys to select YES. Select NO if
you do not wish to change the user setup that is
stored in memory.
4. Press ENTER.
To restore factory or user settings:
1. Press SHIFT and then SETUP.
2. Use the ▲ and ▼ keys to select FACTory or USER.
3. Press ENTER.
NOTE: Factory default settings are listed in Table 2.
Instrument connections
Basic connections for Model 2010 measurements are
shown in Figure 1. These drawings show connections to
the front panel terminals (INPUTS switch in the FRONT
position). If using the rear panel terminals, place the
INPUTS switch in the REAR position. Note that current
(DCI and ACI) measurements cannot be made from the
rear panel terminals.

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz