Keithley 3720 User Manual

Section
2: Using the Front Panel Series 3700 System Switch/Multimeter
User's Manual
2
-12 Document Number: 3700S-900-
01 Rev. A / August 2007
INPUTDIV
Enables or disables the 10M ohm input divider. Related ICL command: dmm.inputdivider
LIMIT
Opens the LIMIT MENU for the selected DMM function. See LIMIT key configuration (on page 2-
14).
LINESYNC
Attribute configuring whether line sync is used during the measurement. Related ICL command:
dmm.linesync
MATH
Selecting the MATH menu item opens the MATH MENU. Items contained in this menu are as
follows:
 ENABLE: Enable or disable math operation on measurements. Related ICL command:
dmm.math.enable
 FORMAT: Specifies the math operation to perform on measurements. Related ICL
command: dmm.math.format
 BFACTOR: Specifies the offset for the y = mx + b operation. Related ICL command:
dmm.math.mxb.bfactor
 MFACTOR: Specifies the scale factor for the y = mx + b operation. Related ICL
command: dmm.math.mxb.mfactor
 MXBUNITS: Specifies the unit character for the y = mx + b operation. Related ICL
command: dmm.math.mxb.units
 PERCENT: Specifies the constant to use for the percent operation. Related ICL
command: dmm.math.percent
NPLC
Configures the integration rate in line cycles for the DMM. Related ICL command: dmm.nplc
OFFSETCOMP
Configures the offset compensation setting for the DMM. Related ICL command:
dmm.offsetcompensation

Keithley 3720 Specifications

General

Brand	Keithley
Model	3720
Category	Multimeter
Language	English