Keithley DMM7510

Safety
UnpackIntroduction
FAQs
Next steps
Connect Explore Test
Connections for testing
To prevent electric shock, test connections must
be confi gured such that the user cannot come
in contact with test leads or any device under
test (DUT) that is in contact with the conductors.
It is good practice to disconnect DUTs from the
instrument before powering the instrument. Safe
installation requires proper shields, barriers, and
grounding to prevent contact with test leads.
Do not apply more than 1000 V
PEAK
to the INPUT
terminals or more than 350 V
PEAK
to the SENSE
terminals. Failure to heed this caution may result
in instrument damage.
Do not apply more than 250 V
PEAK
between INPUT
LO and the AMPS input. Failure to observe this
caution may result in instrument damage.
Do not apply more than 3 A, 250 V to the input.
This will cause the AMPS fuse to open-circuit.