Keithley Interactive SourceMeter 2450 - Page 34

Section
3: Using a remote interface Model 2450 Interactive SourceMeter® Instrument
User's Manual
3-16 2450-900-01 Rev. C / December 2013
To change to the SCPI command set from a remote interface:
Send the command:
*LANG SCPI
Reboot the instrument.
To change to the TSP command set from a remote interface:
Send the command:
*LANG TSP
Reboot the instrument.
To change to the SCPI 2400 command set from a remote interface:
Send the command:
*LANG SCPI2400
Reboot the instrument.
To verify which command set is selected:
Send the command:
*LANG?