1-2 Front Panel Operation Series 2600 System SourceMeters User’s Manual
2600S-900-01 Rev. A / May 2006 Return to In this section:
Safety symbols and terms
The following symbols and terms may be found on the instrument or used in this
manual:
The
!
symbol on an instrument indicates that the user should refer to the
operating instructions located in the manual.
The symbol on the instrument shows that high voltage may be present on the
terminal(s). Use standard safety precautions to avoid personal contact with these
voltages.
The symbol on an instrument shows that the surface may be hot. Avoid
personal contact to prevent burns.
The WARNING heading used in this manual explains dangers that might result in
personal injury or death. Always read the associated information very carefully
before performing the indicated procedure.
The CAUTION heading used in this manual explains hazards that could damage
the instrument. Such damage may invalidate the warranty.
Front and rear panel familiarization
Front panel overview
The front panels of the Series 2600 are shown in Figure 1-1 and Figure 1-2. Sum-
maries of the front panel controls follow these figures.
Set up source and measure functions 1-15
Configure the buffer 1-16
Turn on the output 1-16
Store readings 1-16
Turn off the output 1-16
Recall readings 1-16
To Next Page
Loading...
Need help?
General
