S11
X11
X12
01
R12
2.2. SITING THE MACHINE
By siting of the machine you should take into attention the following:
- Site the machine on a fixed dry base, from which there doesn’t come any dust etc. into
suction air. See to that the machine is positioned away from the line of particle spray, created by
grinding tools etc. Preferably site machine somewhat higher above the floor level.
- See to that in front of the machine as well as at the rear of the machine there is at least 20 cm
(8.0 inches) free distance to allow good circulation of the cooling air through the machine.
- Protect the machine against hard rain and in hot circumstances against direct sunshine. Ensure
the free circulation of the cooling air.
MASTER 2200/0530 – 5
© KEMPPI OY
To Next Page
Loading...
Need help?
General
