5. OPERATION DISTURBANCES
In case of problems contact the KEMPPI works or your KEMPPI dealer.
Check the maintenance objects before the machine is sent to the service repair shop
5.1. OPERATION OF THE OVERLOAD PROTECTION
The overload protections (thermal protections) of the machine operate, if the machine is
continuously loaded above the rated values or the circulation of the cooling air is blocked.
The machine is automatically returned into operation, after it has cooled down t a lower
temperature.
5.2. CONTROL FUSES
As the machine protection there is on control card an 1,0 A slow-blow cartridge fuse in the
safety voltage circuit.
- Reason for burning of a fuse might be a damaged control card.
Use same type and rating of fuse which is marked beside the fuse adapter.
Damage caused by a wrong type fuse, is not covered by the guarantee.
6. DISPOSAL OF THE MACHINE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you should
get information on approved collection systems from our local representative.
By applying this European Directive you will improve the environment and human
health!
7. ORDERING NUMBERS
C 100C 6185410
C 100D 6185413
16c /10 m 6185451
/25 m 6185452
/50 m 6185453
20 /5 m - 25 mm² 6184211
/10 m - 25 mm² 6184212
21 /5 m - 25 mm² 6184201
/10 m - 25 mm² 6184202
T110 Transport unit 6185251
MASTER 2200/0530 – 9© KEMPPI OY
To Next Page
Loading...
Need help?
General
