EN
2.10 USING THE SHOULDER STRAP
1.
3.
2.
4.
Using and xing the shoulder strap
The machine is delivered with a fabric shoulder strap and metal clip set. The shoulder strap
can be used as a convenient and comfortable way to transport both the machine and cables
set. There are two identical metal clips. Fix one clip to each of the metal lifting eyes, located at
the top of the machine. Adjust the shoulder strap to a comfortable length. The machine can
now be carried.
Should you also wish to transport and secure the cables set, place the cable bundle over the
strap as shown, bring the strap and remaining free clip over the top of the cable bundle and
secure to the already fastened clip. As you take the weight of the machine with the strap, the
cable set is clamped securely into position ready for transport.
NOTE! The machine should not be used when hanging from the shoulder strap.
3. MAINTENANCE
NOTE! Be careful when handling electrical cables!
In maintaining the unit, take into consideration the rate of use and the environment it is
used in. When the unit is used properly and serviced regularly, you will avoid unnecessary
disturbances in use and production.
3.1 DAILY MAINTENANCE
• Remove welding spatters from the welding gun’s tip and check the condition of the
parts. Change damaged parts to new ones immediately. Only use original Kemppi spare
parts.
• Change damaged insulation parts to new ones immediately.
• Check the tightness of the welding gun’s and earthing cable’s connections.
• Check the condition of the supply voltage and welding cable and replace faulty cables.
• Check condition of mains and welding cables and replace damaged cables.
• See that there is enough space around the unit for ventilation.
16
MinarcMig Evo 200 / © Kemppi Oy / 1110
To Next Page
Loading...
Need help?
General
