Kemppi MinarcTig 180 Operating Instructions

14 MinarcTig
TM
180
© Kemppi Oy 0615
EN
5. TROUBLESHOOTING
Problem Cause
Main switch indicator
light does not switch on
The machine has no supply voltage
•
Check supply voltage fuses
•
Check supply voltage cable and plug
Machine welds badly Weldingoutcomeisinuencedbyseveral
•
Checkthattheearthingclampisxed
properly,xingpointisclean,andboth
cable and its connections are undamaged
•
Checktheowofshieldinggasfromthe
tip of the welding torch
•
Supply voltage is uneven, too low or too
high
Over-heating indicator
light switches on
The machine has over-heated
•
Checkthatcoolingaircanowwithout
obstructions
•
Machine’s volume-capacity ratio has
beenexceeded;waitfortheindicator
light to switch off
•
The supply voltage is too low or too high
If the machine’s malfunction can not be corrected with these measures, contact the
KEMPPI maintenance service.

Kemppi MinarcTig 180 Specifications

General

Brand	Kemppi
Model	MinarcTig 180
Category	Welding System
Language	English