DARHIRG
WITH
PRESSERFOOT'
1. Turn [eed dog control to right.
2. Press down outer ring of presser loot knob. see page 10. With presser foot knob
in this position, mending, darning, monogram work. etc, may be done.
3. Stretch fabric tightly between two spring cmbrnidery hoops and place under
needle,
4. Lower presser bar so thread will have some tension. "When you start to darn,
move fabric back and forth to cover darning area. Then turn fabric and continue
sewing at right angles to the previous stitching. Use medium machine speed. You
can make any length stitches desired. Slow movement of fabric wilt make short
darning stitches. Fast movement will make long stitches.
5= When you finish darning, raise presser foot m_d remove fabric, Increase pressure
for general sewing by pressing down tuner pin of the presser foot knob. Turn
feed dog c(mtroI to left.
WITHOUTPRESSERFOOT'
1. Turn feed dog control to right,
2. Remove presser foot.
Proceed as directed under steps 3 and 4 above,
5. When you finish darning, raise the presser foot lever and remove fabric. Replace
presser toot, and increase pressure for general sewing. Turn feed dog control to
left.
To Next Page
Loading...
