7.
In order to prevent the
CRT's
fluorescent screen from scorching, do not
adjust the brightness higher than necessary and do not leave the spotting
function
on for long periods of time.
8. The set has been equipped
with
handle, so
that
you can position it in either
horizontal
or diagonal positions. However, do not place any objects on top of
the set or position it in areas where the ventilation holes in the casing are
blocked
in any way.
Such
blockage
will
cause the temperature of the internal
components to increase, resulting in possible
damage
to the unit. Do not put
liquid,
metal or other foreign matters through the vent hole, etc.
9.
Do not use X
1QMAG
during
X-Y
operation. Wave pattern noise
tends
to
occur when X
10MAG
is used.
10.
The
probe
has been manufactured
with
the same
level
of delicate precision as
the oscilloscope itself. Be
very
careful when handling it.
6
To Next Page
Loading...
Need help?
General
