Need help?Do you have a question about the Kenwood CS-1021 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Coupling | AC, DC, GND |
| Trigger Source | CH1, CH2, Line, Ext |
| Acceleration Voltage | 2 kV |
| Sweep Time | 0.2 μs/div to 0.2 s/div |
| Input Impedance | 1 MOhm |
| Trigger Modes | Auto, TV |
| CRT Type | Rectangular, internal graticule |
| Power Supply | 50/60 Hz |
| Weight | 7.5 kg |
Important safety precautions and warnings for operating the oscilloscope and handling power sources.
Measures to protect the oscilloscope from damage and ensure longevity, including screen care and ventilation.
Detailed description and function of controls and indicators located on the front panel.
Step-by-step guide for initial setup and basic operation of the oscilloscope.
Procedure for setting up a normal sweep display for waveform observation.
Procedure for adjusting the probe for accurate waveform measurements.
Method for measuring DC voltage levels using the oscilloscope.
To Next Page
