Kenwood eXcelon KDC-X993 - Tuner Operation; Auto Memory Entry

16
|
KDC-X993/ KDC-HD942U/ KDC-X693/ KDC-MP642U
Tuner Operation
Function of remote control
Direct Access Tuning
Entering the frequency and tuning.
1 Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
“– – – –” is displayed.
2 Enter the frequency
Press the number buttons on the remote
control.
Example:
Desired frequency Press button
92.1 MHz (FM) [0], [9], [2], [1]
810 kHz (AM) [0], [8], [1], [0]
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• You can enter the FM band frequency in steps of a
minimum of 0.1 MHz.
Station Preset Memory
Putting a station in the memory.
1 Select the frequency to put in the memory
Push the Control knob towards right or left.
2 Enter Preset Memory mode
Press the [ ] button.
3 Select the number to put in the memory
Turn the Control knob.
4 Determine the number to put in the memory
Press the Control knob for at least 2 seconds.
Cancelling the Preset Memory mode
Press the [ ] button.
Preset Tuning
Recalling the stations in the memory.
1 Enter Preset Tuning Select mode
Press the [ ] button.
2 Select a desired station in the memory
Turn the Control knob.
3 Recall the station
Press the Control knob.
Cancelling Preset Tuning
Press the [ ] button.
Auto Memory Entry
Putting stations with good reception in the memory
automatically.
1 Enter Auto Memory Entry mode
Select “AUTO MEMORY”.
For how to select Function Control items, refer to
<Function Control> (page 6).
2 Open Auto Memory Entry
Turn the Control knob to select “YES”, and then
press the Control knob.
When 6 stations that can be received are put in the
memory, auto memory entry closes.
Function of KDC-X993/ KDC-X693/ KDC-MP642U
B64-4416-000009FLIPKen.indd16B64-4416-000009FLIPKen.indd16 09.1.73:54:07PM09.1.73:54:07PM