Kenwood eXcelon KDC-X993 - Voice Dialing; Registering Preset Dial Numbers

English
|
23
Make a voice dialing call
1
Enter voice recognize mode
Select “BT” > “Voice Recognize”.
For how to select Function Control item, refer to
<Function Control> (page 6).
“Ready” is displayed.
2 Press the Control knob.
“PB Name?” is displayed.
When a beep is heard, utter the name within 2
second.
3 “PN Type” is displayed.
When a beep is heard, utter the category within 2
second.
4 Make a call
Press the Control knob for at least 1 second.
• This step is the same as step 3 of the procedure in
<Calling a number in the Phone Book>. You can make a
call or select a category.
⁄
• If your voice cannot be recognized, a message is
displayed. Pressing the Control knob allows you to retry
voice input. (page 54)
• Both the name and category requires registration of a
voice tag. (page 39)
• Audio sound is not output during voice recognize.
Registering to the Preset Dial Number
List
1
Enter the phone number you wish to register
Enter the phone number with reference to the
following:
Dial a number/ Calling a number in the call log/
Calling a number in the Phone Book
2 Enter Preset Memory mode
Press the [ ] button.
3 Select the number to put in the memory
Turn the Control knob or push it towards up or
down.
4 Determine the number to put in the memory
Press the Control knob for at least 1 second.
Exit the Preset Memory mode
Press the [ ] button.
Display of phone number type
(category)
The category items in the Phone Book are displayed
as follows:
Display Information
“GENERAL” / “
” General
“HOME” / “
”
Home
“OFFICE” / “ ” Office
“MOBILE” / “
” Mobile
“OTHER” / “
” Other
B64-4416-000009FLIPKen.indd23B64-4416-000009FLIPKen.indd23 09.1.73:54:07PM09.1.73:54:07PM