Kenwood eXcelon KDC-X993 - Setting Voice Commands for Categories

English
|
39
Select “PB Name Delete” (Delete)
5 Delete a voice tag
Press the Control knob.
6 Turn the Control knob to select “YES”, and then
press the Control knob.
Exit Phonebook name edit mode
Press the [FNC] button.
⁄
• Audio sound is not output during voice tag registration.
Setting a Voice Command for
Category
Add a voice tag to the phone number category
(type) for voice calling.
1 Select Phone Number type edit mode
Select “BT”
> “Voice Tag” > “PN Type Edit”.
For how to select Function Control item, refer to
<Function Control> (page 6).
2 Enter Phone Number type edit mode
Press the Control knob.
3 Select the category (type) you wish to set
Turn the Control knob and push the center
when the desired category name is displayed.
“General”/ “Home”/ “Office”/ “Mobile”/ “Other”
4 Select a mode
Turn the Control knob.
Display Operation
“PN Type Regist” Register a voice tag.
“PN Type Check”* Play a voice tag.
“PN Type Delete”* Delete a voice tag.
“Return” Return to step 2.
* Displayed only when a name for which a voice tag has
been registered is selected.
5 Register the category (type) by performing
steps 5 to 7 in <Adding a voice dialing
command> (page 38).
6 Exit Phone Number type edit mode
Press the [FNC] button.
⁄
• Set the voice tag for all the 5 categories. If the voice tag
is not registered for all the categories, the Phonebook
may not be recalled by voice command.
B64-4416-000009FLIPKen.indd39B64-4416-000009FLIPKen.indd39 09.1.73:54:09PM09.1.73:54:09PM