CHARACTER ENTRY
While in the character entry screen, you can use the following two methods to enter
the characters:
o
Pressing the [
J
]/[
K
] keys
Press [J]/[K] to cycle the characters from A ~ Z, a ~ z, 0 ~ 9, and a space (default
settings).
You can also assign a character to an optional key and later press that key to recall
the assigned character: A ~ Z, a ~ z, 0 ~ 9, or a space and characters.
o
Using the keypad (Full key models only)
Press the keypad keys to enter characters as shown in the table below.
You can press the [ ] or [ ] key repeatedly to switch the input mode (upper case B
lower case B numbers B back to beginning).
Keypad Character Cycle (Upper Case) Character Cycle (Lower Case)
1 @ # " ( ) ! $ _ @ # " ( ) ! $ _
2 A B C a b c
3 D E F d e f
4 G H I g h i
5 J K L j k l
6 M N O m n o
7 P Q R S p q r s
8 T U V t u v
9 W X Y Z w x y z
0 (space) . , ? / ' & (space) . , ? / ' &
25
To Next Page
Loading...
Need help?
General
