Model : The model number of a registered Bluetooth-enabled device
that supports Device Information Service.
Serial : The serial number of a registered Bluetooth-enabled device
that supports Device Information Service.
Hardware Ver. : The hardware version of a registered Bluetooth-enabled
device that supports Device Information Service.
Firmware Ver. : The firmware version of a registered Bluetooth-enabled
device that supports Device Information Service.
Software Ver. : The software version of a registered Bluetooth-enabled
device that supports Device Information Service.
Device Class Disconnected Connected
Audio/Video
Phone
Computer
LAN/Network
Peripheral
Imaging
Wearable
Toy
Health
Note:
●
You can also check the information of the devices in the Find Device mode.
●
The icons listed in the above table indicate the connection status of the Headset Profile,
Heart Rate Service and Automatic Injury Detection Service. They are not applicable to the
Serial Port Profile connection.
o
Switching the speaker audio output
You can switch the audio output between the speaker of the transceiver and the
Bluetooth headset.
Press the key programmed as [Bluetooth Speaker] to change the setting (“Off” or
“Only”).
Alternatively, press the key programmed as [Menu] to enter Bluetooth Speaker Mode
using the Menu Mode. Press the [J] and [K] keys to select “Off” or “Only”.
Off : Audio is output from the built-in speaker of the transceiver.
Only : Audio is output from the speaker of the Bluetooth device.
Press the [
] or [ ] key to confirm your selection.
72
To Next Page
Loading...
Need help?
General
