MODEL NAME SETTING VOLT AGE
ADJUSTMENT
VOLTAGE
ADJUSTMENT
RANGE
SHUNT
REGISTER
CH1 0.300 A 0.300 V
PW18-3ADP
CH2 0.300 A 0.300 V
CH1 0.100 A 1.000 V
CH2 0.200 A 0.100 V
PW18-2ATP
CH3 0.200 A 0.200 V
CH1 0.300 A 0.300 V
PW16-5ADP
CH2 0.500 A 0.500 V
CH1 0.300 A 0.300 V
CH2 0.300 A 0.300 V
PW8-3ATP
CH3 0.150 A 0.150 V
CH1 0.100 A 1.000 V
CH2 0.100 A 1.000 VPW26-1AT
CH3 0.500 A 0.500 V
CH1 0.150 A 0.150 V
PW36-1.5ADP
CH2 0.150 A 0.150 V
CH1 0.130 A 0.130 V
CH2 -0.130 A -0.130 VPW18-1.3ATS
CH3 0.500 A 0.500 V
CH1
0.100
A
1.000 V
CH2 0.100A 1.000 V
PW26-1ATS
CH3 0.500 A 0.500 V
After current adjustment end, when adjust other channels, adjust in the same procedure from 5-4-2.
When ending current adjustment, press the long pushing of KEYLOCK key (more than 2 seconds), cancel the current
adjustment mode.
4. The end of adjustment
If complete all adjustments of the voltage current of each output, turn OFF a power supply switch.
(Or press the long pushing of KEYLOCK key {2 seconds or more} several times {3 times or more}, and escape from
the adjustment mode. And turn OFF the power supply switch)
* The model with YB is all the same as the basic model.
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω
± 1 mV
1 Ω