TK-3170
38
Controls
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode.
To enter test mode,
press [A] key and turn power on. Hold [A] key until fre-
quency version appears on LCD.
Test mode can be inhib-
ited by programming. To exit test mode, switch the power
on again. The following functions are available in test mode.
■ Key operation
Key Function Display
[S]
Shifts to Panel tuning mode
-
[A] Low transmit power “ ” appears
[B]
MSK 1200bps and 2400bps 2400bps : icon appears
[C] Test signaling CH up Signaling No.
[Selector]
Test frequency CH up/down
Channel No.
[Side1] Squelch on/off
[Side2] Narrow/Wide 5k/Wide 4k Narrow : “N”
Wide 5k : “W”
Wide 4k : “S”
[PTT] Transmit -
[0] to [9] Use as the DTMF keypad. -
and [#], If a key is pressed during
[
*
] transmission, the DTMF
corresponding to the key
that was presses is sent.
[AUX] Segment check All segment appears
Note :
• If a [S], [A], [B], [C] key is pressed during transmission, the
DTMF corresponding to the key that was pressed is sent.
• LED indicator
Red LED Lights during transmission. Blinks at the low
battery voltage warning.
Green LED Lights when there is carrier.
ADJUSTMENT
Selector
Volume
PTT
Side1
Side2
AUX
■ Frequency and Signaling
The set has been adjusted for the frequencies shown in
the following table. When required, readjust them following
the adjustment procedure to obtain the frequencies you want
in actual operation.
• Test frequency
CH
EX2
RX (MHz) TX (MHz) RX (MHz) TX (MHz)
1 455.05000 455.10000 495.05000 495.10000
2 440.05000 440.10000 470.05000 470.10000
3 469.95000 469.90000 519.95000 519.90000
4 455.00000 455.00000 495.00000 495.00000
5 455.20000 455.20000 495.20000 495.20000
6 455.40000 455.40000 495.40000 495.40000
7~16 - - - -
• Test signaling
No. RX TX
1 None None
2 None 100Hz Square Wave
3 Skip Skip
4 QT : 67.0Hz QT : 67.0Hz
5 QT : 151.4Hz QT : 151.4Hz
6 QT : 210.7Hz QT : 210.7Hz
7 QT : 254.1Hz QT : 254.1Hz
8 DQT : 023N DQT : 023N
9 DQT : 754I DQT : 754I
10 DTMF : 159D DTMF : 159D
11 None DTMF Code 9
12 Skip Skip
13 Single Tone : 979.9Hz Single Tone : 979.9Hz
14 None Single Tone : 1000Hz
15 5-tone : 12345 (CCIR) 5-tone : 12345 (CCIR)
16 None MSK
17 MSK : MSK :
Preamble : 0xAAAA Preamble : 0xAAAA
Sync : 0x23EB Sync : 0x23EB
Data : 0x230960C6AAAA Data : 0x230960C6AAAA
CRC : 0xC4D7 CRC : 0xC4D7
N11
–
Channel No.
N : Narrow
W : Wide 5k
S : Wide 4k (E type only)
Signaling No.
• LCD display in panel test mode