To Next PageTo Next Page
Need help?Do you have a question about the Kenwood TK-7162 E and is the answer not in the manual?
General| Frequency Range | 136-174 MHz |
|---|---|
| Channel Capacity | 128 channels |
| Power Output | 25W |
| Weight | 1.1 kg |
| Modulation | 16K0F3E / 11K0F3E |
| Voltage | 13.6V DC |
| Type | Mobile |
| Channel Spacing | 12.5 / 25 kHz |
Essential safety guidelines for operating the equipment.
Description of buttons and functions on the front panel.
Lists functions assignable to keys.
Procedures for PC-based programming and setup.
Steps to enter and use self-programming mode.
Step-by-step guide for installing the KCT-39 cable.
Steps to enable ignition sense function.
Detailed description of the receiver signal path.
How the CPU controls various transceiver functions.
Explanation of the power supply and protection circuits.
Explanation of the final power amplification stage.
Details on generating local oscillator and RF signals.
Detailed pin assignments and functions for IC101.
Details for various types of capacitors used in the unit.
Details for various types of resistors used in the unit.
Specific parts list for the TX-RX unit.
Continuation of parts for the TX-RX unit.
Visual breakdown of the transceiver's assembly.
List of required test equipment for alignment procedures.
Procedures for adjusting DQT, MAX balance, and deviations.
Frequency table and diagram for level adjustments.
Procedures for adjusting squelch levels for different channels.
Steps for adjusting components on the PCB.
Procedures for adjusting transmitter power output.
Details on port assignments for various accessories.
Component layout diagram for the TK-7160 display unit.
Foil side layout diagram for the TK-7160 display unit.
General operating parameters and standards compliance.
Performance metrics for the receiver section.
Performance metrics for the transmitter section.
