Kenwood TK-3170 E - Page 8

TK-3170
8
REALIGNMENT (Signaling type for Decode = 5-tone)
No. Function Choices Display Remarks
14 Direct Channel NO Default=NO
1~4
15 Primary Address Code which it can input, 0~9 (about 0.5 seconds)
and A~E, maximum of 8 digits. Display of the current setting
Display when a code is input
DIRCT _ _ 1
DIRCT _NO
PR I _ADDR
___12345
___52134
Self programming mode
Channel select mode Zone select mode
RX frequency
RX signaling
TX frequency
TX signaling
System reference
Transmit power
[Side2]
[A]
[C]
[B] (Write data)
[C] (Don’t write data)
[B] (Write data)
[C] (Don’t write data)
[B] (Write data)
[C] (Don’t write data)
[B] (Write data)
[C] (Don’t write data)
Wide 5k/Wide 4k/Narrow
[B] (Write data)
[C] (Don’t write data)
[B] (Write data)
[C] (Don’t write data)
[B] (Write data)
[C] (Don’t write data)
Busy channel lockout
[B] (Write data)
[C] (Don’t write data)
Scan delete/add
[B] (Write data)
[C] (Don’t write data)
Beat shift
[B] (Write data)
[C] (Don’t write data)
Compander
[B] (Write data)
[C] (Don’t write data)
Priority channel
[B] (Write data)
[C] (Don’t write data)
Home channel
Direct channel
[B] (Write data)
[C] (Don’t write data)
Primary address
[B] (Write data)
[C] (Don’t write data)
[B] (Write data)
[C] (Don’t write data)
Blank
[Side1]
Blank
[Side1]
Blank DQT N DQT IQT
[Side1] [Side1] [Side2][Side1]
[Side1]
Blank DQT N DQT IQT
[Side1] [Side1] [Side2][Side1]
[Side1]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
[S]
Not used when Direct CH/GID
is not set in Key Assignment
■ Channel edit mode flow chart