To Next Page

To Previous Page

440-BA-defsi-0634

9.3.3 AU PC

Weight readings will be sent automatically and continuously, no matter the weight

reading is stable or unstable.

e. Stable weight/pieces/percentage format

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

B B B B B B B B 0 . 0 B g B B CR LF

f. “Error” format

1 2 3 4 5 6 7 8 9 10 11 12 13 14

B B B B B B B E r r o r CR LF

g. unstable weight/pieces/percentage format

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

B B B B B B B B 0 . 0 B CR LF

9.3.4 rE Cr

Remote commands s/w/t will be sent from the remote to the balance as ASCII

code. When the balance received the s/w/t command, following data will be trans-

mitted.

s function: a stable weight reading is sent via RS232 interface

w function: a weight reading (stable or unstable) is sent via RS232 interface

t function: no data transmitted, balance perform Tare function.

h. stable weight/pieces/percentage format

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

B B B B B B B B 0 . 0 B g B B CR LF

i. “Error” format

1 2 3 4 5 6 7 8 9 10 11 12 13 14

B B B B B B B E r r o r CR LF

j. unstable weight/pieces/percentage format

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

B B B B B B B B 0 . 0 B CR LF

SYMBOLS:

= Blank or M

B / 0 /

= Blank / weigh reading / decimal point, depending on the weight

reading

g = weight unit / pieces / %

E, o, r = ASCII CODE of “E, o, r”

CR = Carriage Retur

LF = Line Feed

KERN 440 Operating Instructions

Other manuals for KERN 440