440-BA-defsi-0634
41
7 Operation
7.1 Overview of display
7.2 Weighing
Switch the balance on by pressing the key.
The balance will show “88888“ for approx. 3 seconds and then change to “0“. Now it
is ready for use.
Important: If the display does not show “0“ press the key.
Only now (!) place object on the weighing pan. Make sure that the weighing object
does not stripe or touch the housing or base.
Now the weight will be indicated. After a successful „resting position“ control the
weighing unit (e.g. g or kg) will appear on the far right at the bottom of the display.
If the object should be heavier than the weighing range allowance, the symbol “E“
(overload) will appear on the display and a tone can be heard.
7.3 Taring
Switch the balance on by pressing the key, then wait for the “0“ indication.
Place the jiffy on the weighing pan and press the key. Display again shows
“0“. Now the weight of the jiffy is memorised internally.
By pressing the key after a weighing procedure, “0“ will appear on the display
again.
The taring procedure can be repeated continuously, for instance when mixing several
components.
The limit is reached when the full weighing range is overlaid.
After having removed the jiffy the total weight will appear as a minus indication.
To Next Page
Loading...
Need help?
General
