440-BA-defsi-0634
42
7.4 Plus / Minus Weighings
For instance to control piece-weights, filling process control etc.
Switch the balance on by pressing the key, then wait until “0“ is indicated.
Place rated weight on the weighing pan and tare on “0“ by pressing the key.
Remove rated weight.
Place the objects on the weighing pan successively, the balance will show any devia-
tion from the rated weight in “+“ and “-“.
According to the same procedure packages with the same weight, related to a rated
weight, can be produced.
Return to the weighing mode by pressing the key.
7.5 Piece counting
Switch the balance on by pressing the key, then wait until “0“ is indicated.
Briefly press the key.
Reference number 5 will appear.
To call up the reference numbers 10, 25 and 50 press the key several times.
Put so many pieces on the weighing pan as the set reference number requires.
Confirm by pressing the key.
The balance is now in the piece counting mode and will count all pieces laying on the
weighing pan.
By pressing the key the balance returns to the weighing mode and displays the
weight of the counted pieces.
Important: The higher the reference number, the more accurate the piece
counting is.
See the table “Technical Information“ on page 12 for minimum counting weight. If the
number of pieces is below the minimum weight the display shows “Er1“. Return to the
weighing mode by pressing the key.
Jiffies can also be used to count pieces. Tare the jiffy by pressing the
key be-
fore beginning the piece counting operation.
To Next Page
Loading...
Need help?
General
