- 11 - PNJ_PNS-SH-e-2011
6 Inspection of electrical section (AJDP circuit board)
During inspection of the electrical section, remove the AJDP circuit board and
check the board and check at CN1, CN4, TP4, and TP6.
1. Check the supply voltage
of TP0-CN1: +5.7 to +6.3 V
2. Check supply voltage within the circuit
of TP0-CN4: +4.75 to +5.25 V
TP 0 to TP 1: +3.0V ~ +3.6V
2. Check the signal waveform
To Next Page
Loading...
