16:30
Arming
OK.Ent e r ES C . Retur n
ESC.返回
Number Settings
1.Alarm numbers
2.CID numbers
3.Help numbers
4.SMS numbers
5.Voice calls
Picture 3-1
Number Settings
OK.Ent e r ES C . Retur n
13-11-08
THU
OK.Ent e r ES C . Retur n OK.Ent e r ES C . Retur n OK.Ent e r ES C . Retur n
System Settings
1.Delay Settings
2.Password Settings
3.Voice Settings
4.Siren Settings
5.Phone&SMS Settings
Delay Settings
Arming delay:00
Alarm delay:00
Password Settings
Password:1234
Keypad Lock:OFF
Picture 3-3 Picture 3-4 Picture 3-5
3.8.2 Password Set
On system setting page, press key【UP/DOWN】to move the cursor behind【
Password Set】 then press key【OK】or number 2 to enter password set page, as ,
shown in picture 3-4.
3.8.2.1 System Password
On password setting page, input four digits new passwords in System Password (
original password is 1234), press key 【OK】to save.
3.8.2.2 Keypad Password
On password setting page, press key【DOWN】to move the cursor behind【Keypad
Password Set】 press key【MENU】 to switch it ON or OFF and press key【OK】to ,
save setting. If the lock function of keypad is open, host will lock when it enters
into dormancy or alarm state. Unlock the keypad by inputing the password. The
factor y default is unlock.
3.8.3 Voice Setting
On system setting page, press key 【UP/DOWN】to move the cursor behind【Voice
Setting】 then press key【OK】or number 3 to enter Voice Setting page, as shown ,
in picture 3-6.
3.8.3.1 System Volume
On voice setting page, put the cursor on【System Volume】 input volume level ,
0-7, then press key【OK】to save the setting. 0 means mute during the operation
to host, and 7 means the largest volume, as shown in picture 3-7. The factor y
default is level 5.
3.8.3.2 System Voice
On voice setting page, press key【DOWN】to move the cursor behind【System
Voice】 press key【MENU】 to switch it ON or OFF and press key 【OK】to save ,
setting. If switch it off, there is no voice prompt only button voice during operation.
The factory default is on.
System volume:5
System voice:ON
Built-in volume：05
Siren on time:01
Picture 3-6 Picture 3-7 Picture 3-8
Voice Settings Siren Settings
OK.Ent e r ES C . Retur nOK.Ent e r ES C . Retur nOK.Ent e r ES C . Retur n
3.8.4 Siren Setting
On system setting page, press key 【UP/DOWN】to move the cursor behind【Siren
Setting】 then press key【OK】or number 4 to enter Siren Setting page, as shown ,
in picture 3-8.
3.8.4.1 Internal Siren Volume
On siren setting page, input volume level 0-7, then press key 【OK】to save the
setting. 0 means mute, and 7 means the largest volume, as shown in picture 3-8.
The factory default is level 5.
3.8.4.2 Siren Alarm Time
On siren setting page, press key 【DOWN】to move the cursor behind【Siren Alarm
Time】. The siren alarm time is between 0-20 minutes, then press key【OK】 to
save setting. 0 means mute, the factor y default is 1 minute.
3.8.5 Phone Message Setting
On system setting page, press key 【UP/DOWN】to move the cursor behind【Phone
Message Setting】 then press key【OK】or number 5 to enter phone message ,
setting page, as shown in picture 3-8.
3.8.5.1 Message Reply
On phone message setting page, press key【MENU】 to switch it ON or OFF and
press key【OK】to save setting. If switch on, the host will send message to advise
wheather settings are correct when users do settings by message. The factory
default is on.
3.8.5.2 Alarm Output
On phone message setting page, press key 【DOWN】to move the cursor behind
【Alarm Output】 press key【MENU】 to switch it ON or OFF and press key【OK】,
to save setting. If switch on, relay will shortcut output while the host alarming,
COM and NO shortcut. The factor y default is on.
Picture 3-9 Picture 3-10
OK.Ent e r ES C . Retur nOK.Ent e r ES C . Retur n
Picture 3-11
OK.Ent e r ES C . Retur n
1.Delay Settings
2.Password Settings
3.Voice Settings
4.Siren Settings
5.Phone&SMS Settings
1.Delay Settings
2.Password Settings
3.Voice Settings
4.Siren Settings
5.Phone&SMS Settings
Phone&SMS Settings
SMS reply:ON
Alarm out:ON
Enter Number(00-99)：01
Sound Settings Sound Settings
Siren Sound ON：
System Settings
To Next Page
Loading...
