B3000 SERVICE MANUAL
60-200807-000, REV C 26
9. Draining the Brewer
When you wish to drain the brewer, the following steps must be followed:
1. Press the power button to the “0” position and unplug power cord.
2. Shut off water and disconnect water supply to the brewer. Turn the brewer around so the back is
facing you.
3. Move the brewer close to the edge of a sink or large bucket so that the drain hoses hang over
either the sink edge or into the bucket
4. Remove both the Hot Water and Cold Water hoses from their clips. Remove drain plugs from
each hose.
CAUTION: THE WATER WILL BE VERY HOT!
5. When the flow of water stops, the brewer’s internal hot water tank and cold water tank will be
empty.
NOTE: The brewer is drained by gravity. It will take approximately 3 minutes to
complete. There will always be a small amount of water left in the drain hoses.
To Next Page
Loading...
