B3000 SERVICE MANUAL
60-200807-000, REV C 52
G. COLD WATER PUMP MODULE (Located in the middle of the brewer)
See REMOVAL of OUTER PANELS (page 36). After completion of panel removal, the technician
must attach an ESD wrist strap to themselves and the metal base plate of the brewer.
Looking at the rear, in the middle of the brewer you will see the Cold Water Pump module.
1. Disconnect the hose on the top of each pump, two places.
2. Prior to disconnecting the four wire connections attached to bottom of the green water pumps
make a note of their respective connections.
To Next Page
Loading...
