B3000 SERVICE MANUAL
60-200807-000, REV C 57
5. Locate the two hinge pins connecting the door to the brewer.
6. Using a flat screw driver, gently pry the hinge pins up and out.
7. Carefully pull the wire harness through the opening.
8. The Door Module can now be removed.
9. Install the new module and connect the appropriate wire connection, cover plate and reinsert the
hinge pins making sure that they are secure and tight.
10. Conduct a BIT test (see appendix VII on page 85) to insure the proper function of the brewer.
To Next Page
Loading...
