Keysight 34980A Service Guide 3
Safety Symbols
The following symbols on the instrument and in the documentation indicate
precautions which must be taken to maintain safe operation of the instrument.
Safety Considerations
Read the information below before using this instrument.
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards for design, manufacture, and intended use of the instrument. Keysight
Technologies assumes no liability for the customer’s failure to comply with these
requirements.
General
Do not use this products in any manner not specified by the manufacturer. The
protective features of this product may be impaired if it is used in a manner not
specified in the operation instructions.
Before Applying Power
Verify that all safety precautions are taken. Make all connections to the unit before
applying power.
Alternating current (AC) Frame or chassis (ground) terminal
Standby supply. Unit is not completely
disconnected from ac mains when
switch is off
Caution, risk of electric shock
Caution, risk of danger (refer to this
manual for specific Warning or Caution
information)
To Next Page
Loading...
Need help?
General
