Keysight Technologies 8163A/B - Returning the Instrument to Local Control

12 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
1 Introduction to Programming
Returning the Instrument to Local Control
If the instrument is in remote control, a screen resembling
Figure 1 on page -12 will appear. Press [Local] if you wish to return the
instrument to local control.
Figure 1 Remote Control
NOTE
If your 8163A/B, 8164A/B or 8166A/B mainframe is in local lockout mode (refer
to
:DISPlay:LOCKout on page 226) the Local softkey is not available.