32 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
2 Specific Commands
Specific Command Summary
The commands are ordered in a command tree. Every command belongs
to a node in this tree.
The root nodes are also called the subsystems. A subsystem contains all
commands belonging to a specific topic. In a subsystem there may be
further subnodes.
All the nodes have to be given with a command. For example in the
command
disp:brig
• DISPlay is the subsystem containing all commands for controlling the
display,
•BRIGhtness
is the command selecting brightness.
Table 4 on page 32 gives an overview of the command tree. You see the
nodes, the subnodes, and the included commands.
Table 4 Specific Command Summary
If a command and a query are both available, the command ends /?.
So,
disp:brig/? means that disp:brig and disp:brig? are both available.
Command Description Page
:CONFigure[n][:CHANnel[m]]:OFFSet
:WAVelength:REFerence/? Sets or queries the slot and channel of the external reference power meter. page 198
:WAVelength:STATe/? Switches or queries attenuator Offset Table on or off? page 197
:WAVelength:TABle? Queries the complete offset table. page 201
:WAVelength:TABle:SIZE? Queries the size of the offset table. page 201
:WAVelength:VALue Adds a value pair (wavelength, offset) to the offset table. page 198
:WAVelength:VALue:DELete Deletes an offset value pair. page 200
:WAVelength:VALue:DELete:ALL Deletes all value pairs from the offset table. page 201
:WAVelength:VALue:OFFSet? Queries an offset value according to wavelength or index. page 199
:WAVelength:VALue:PAIR? Queries an offset/wavelength value pair according to wavelength or index. page 200
To Next Page
Loading...
