8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 33
Specific Commands 2
:WAVelength:VALue:WAVelength? Queries a wavelength value from its index in the offset table page 199
:DISPlay
:BRIGhtness/? Controls or queries the current display brightness. page 225
:CONTrast/? Controls or queries the current display contrast. page 224
:ENABle/? Switches the display on or off, or queries whether the display is on or off. page 226
:LOCKout/? Sets or queries local lockout mode. page 226
:FETCh[n][:CHANnel[m]][:SCALar]
:POWer[:DC]? Returns a power value from a sensor. page 88
:RETurnloss? Returns the current return loss value. page 88
:INITiate[n]:[CHANnel[m]]
[:IMMediate] Starts a measurement. page 89
:CONTinuous/? Starts or Queries a single/continuous measurement. page 89
:LOCK/? Switches the lock on/off or returns the current state of the lock. page 80
:INPUT[n][:CHANnel[m]]
:ATTenuation/? Sets or returns the attenuation factor for the instrument. page 182
:OFFset/? Sets or returns the offset factor for the instrument. page 183
:OFFset:DISPlay Sets the offset factor so that attenuation factor is zero. page 183
:OFFset:POWermeter Sets the offset factor to the difference between the power measured with a
powermeter and with the monitor diode.
page 184
:ATTenuation:SPEed/? Sets or queries the filter transition speed page 184
:WAVelength/? Sets or queries the modules attenuation wavelength page 185
:OUTPut[n][:CHANnel[m]]
:APMode/? Sets or queries whether power setting or attenuation value has been changed. page 185
:APOWeron/? Sets or queries the shutter status at power on. page 193
:ATIMe/? Sets or queries the powermeter averaging time. page 194
:CONNection/? Selects or returns Analog Output parameter. page 122
:CORRection:COLLection:ZERO Zeros the offsets of attenuators powermeter page 195
Command Description Page
To Next Page
Loading...
