Keysight Technologies 8163A/B - Page 34

34 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
2 Specific Commands
:CORRection:COLLection:ZERO:ALL Zeros all available powermeter channels in mainframe page 195
:CORRection:COLLection:ZERO? Queries the status of the last zero operation page 195
:PATH/? Sets or returns the regulated path. page 122
:POWer/? Sets or queries the output power value. page 187
:POWer:CONTRol/? Sets or queries power control mode status page 191
:POWer:OFFSet/? Sets or queries the power offset value. page 190
:POWer:OFFSet:POWermeter Calculates power offset from measured power values page 190
:POWer:REFerence/? Sets or queries the reference power value. page 189
:POWer:REFerence:POWermeter Copies power value from power meter to attenuator module ref. power
parameter
page 189
:POWer:UNit/? Sets or queries power unit used (dBm or W) page 192
[:STATe]/? Sets a source’s or attenuators output terminals to open or closed or returns
the current status of a source’s or attenuators output terminals.
page 123
:READ[n][:CHANnel[m]]
[:SCALar]:POWer[:DC]? Reads the current power value from a sensor. page 92
:POWer[:DC]:ALL? Reads all available power meter channels. page 91
:POWer[:DC]:ALL:CONFig? Return all the slot and channel number of every available power meter
channel.
page 92
[:SCALar]:RETurnloss? Reads the current return loss value. page 93
:ROUTe[n]
[:CHANnel[m]]/? Sets or returns the channel route between two ports. page 206
[:CHANnel[m]]:CONFig? Reads the switch configuration of an instrument. page 207
[:CHANnel[m]]:CONFig:ROUTe? Reads the allowed switch routes of an instrument. page 207
Command Description Page